Ground and Rock Anchors Design Workshop (1.2 CEUs)

Daily Schedule:
12:00pm MST - Session begins
3:00pm MST - Adjournment
This course is divided into four sessions. Each session will be 3 hours in duration. The sessions will be held on May 31, June 1, 3 & 4.
If you are unable to attend any of the sessions a recording will be made available. 
Strengthening and stabilizing soil and rock masses, and resisting structural movements are achieved by anchoring via prestressed reinforcement. To withstand lateral forces, temporary tie-backs in soil are also necessary for successful construction of shallow foundations.

Ground and Rock Anchors have vast engineering applications and could be used in many projects either within the new design phase or after construction to strengthen components.
Ground and Rock Anchors are important components of ground support, soil improvements, foundation underpinning, wall support and endless other applications. This course is focused on the design, construction and protection of Ground and Rock Anchors.


This practical and informative course would be beneficial for practicing engineers, technicians and technologists interested in safe and economic methods for strengthening engineering structures.

The objective of this course is to provide an in depth review of design, applications and installation methods for anchoring in rock and soil.

After you attend this course you will be able to:

  • Understand the design procedures of ground and rock anchors
  • Perform design for variety of different ground and rock anchors
  • Select the right anchors materials for the right site conditions
Special features

A project design workshop will be conducted under the instructor supervision, please bring in your calculator.
A revision and demonstration of available commercial design software will be introduced.

Target Audience

Practicing engineers, technicians and technologists interested in safe and economic methods for strengthening engineering structures.
This course will be of interest to a wide range of technical personnel who wish to increase their understanding of ground anchors.
  • Consultants
  • Structural engineers
  • Civil engineers
  • College and university faculty
  • Public works and construction department employees of federal, provincial and municipal governments
  • Engineers responsible for large industrial, commercial or institutional facilities who must deal with different types of foundations
The course will be of interest to a wide range of practicing civil engineers at different stages in their careers. Some familiarization with soil mechanics is desirable but the knowledge is not required at a specialist level. The course will be most beneficial to geotechnical engineers, engineering geologists, foundation designers, project engineers, and highway/bridge engineers who are involved in the design and construction of foundations.

Dr. Gamal Abdel Aziz

Dr. Gamal Abdelaziz, P.Eng, MSc. has a Ph.D. in Geotechnical Engineering from Concordia University, Montreal, Canada.

Dr. Abdelaziz has served as a senior geotechnical engineer at DST Consulting engineers, Sarafinchin Consulting engineers, Trow Consulting and EBA engineering. Currently he is the managing director of SAGA Engineering, Edmonton, AB, Canada. 

Dr. Abdelaziz has over 32 years of experience in geotechnical and structural engineering, foundation design, teaching, research and consulting in Canada and overseas.

Dr. Gamal has designed and delivered over one hundred geotechnical engineering workshops which are very well received by practitioners engineers in Canada and globally.

Currently he is a senior geotechnical engineer with SAGA Engineering, Edmonton, Alberta. His duties include revision of geotechnical design, including slope stability, foundation and machine foundation design, soil investigation, design of cuts and earthfills, evaluation of stability of existing slopes, slope reinforcement using geotextiles, geogrids, soil nails, base reinforcement to support earthfills on soft subgrade soils, Erosion protection using geocells matting, rip rap, stabilization of unstable slopes, evaluation of soil bearing capacity to support footing foundations, Settlement studies, deep foundations including driven piles, auger injected (CFA) piles, additional support to existing foundations by underpinning utilizing concrete panels, grouting, micropiles, evaluation of earth pressures on retaining walls, security of excavation base, tieback support, etc.

Dr. Abdelaziz is a former adjunct professor at University of Western Ontario, London, Ontario, Canada, visiting professor at Ryerson University, Toronto, Canada and part time professor at Seneca College, Toronto, Canada.

Dr. Abdelaziz is specialized in numerical modeling for solving sophisticated geotechnical engineering problems with respect to pile foundation and the linear and nonlinear analysis of soil-structure interaction. He designed charts to predict pressures acting on tunnels, and developed an analytical model for pile bearing capacity prediction.

Dr. Abdelaziz authored a number of technical papers and delivered numerous internal and external workshops on various geotechnical and Municipal engineering topics. Dr. Abdelaziz has been involved in a number of projects in Canada and overseas, such as tunneling, silos, buildings, retaining structures, siphons, irrigation networks and many other civil engineering projects in terms of design and construction.

Ground Anchors

  • Types of Ground Anchors
  • Straight Shaft Gravity-Grouted Ground Anchors
  • Straight Shaft Pressure-Grouted Ground Anchors
  • Post-grouted Ground Anchors
  • Underreamed Anchors
  • Tendon Materials
  • Steel Bar and Strand Tendons
  • Spacers and Centralizers
  • Epoxy-Coated Bar and Epoxy-Coated Filled Strand
  • Other Anchor Types and Tendon Materials
  • Cement Grout
Anchored Walls
  • Soldier Beam and Lagging Wall
  • Soldier Beam
  • Lagging
  • Construction Sequence
  • Continuous Walls
Applications of Ground Anchors
  • Highway Retaining Walls
  • Slope and Landslide Stabilization
  • Tiedown Structures
Site Investigation and Testing

Field Reconnaissance

Subsurface Investigation

  • Soil and Rock Stratigraphy
  • Groundwater
Laboratory Rock and Soil Testing
  • Classification and Index Properties
  • Shear Strength
  • Consolidation
  • Electrochemical Criteria
  • In Situ Soil And Rock Testing
  • Basic Principles Of Anchored System Design
  • General Design Concepts For Anchored Walls
  • Failure Mechanisms Of Anchored Systems
  • Failure Mechanisms Of The Ground Anchor
  • Failure of Soldier Beams
  • Failure of Lagging
Selection of Soil Shear Strength Parameters for Design
  • Drained Shear Strength of Granular Soils
  • Undrained Shear Strength of Normally Consolidated Clay
  • Undrained Shear Strength of Overconsolidated Clay
  • Drained Shear Strength of Overconsolidated Clay
Earth Pressures
  • Active and Passive Earth Pressure
  • Earth Pressure at Rest
  • Influence of Movement on Earth Pressure
Design of Anchored Systems

Evaluation of Earth Pressures for Wall Design

  • Introduction
  • Background
  • Terzaghi and Peck Apparent Earth Pressure Diagrams
  • Recommended Apparent Earth Pressure Diagram for Sands
  • Recommended Apparent Earth Pressure Diagram for Stiff to Hard Fissured Clays
  • Recommended Apparent Earth Pressure Diagram for Soft to Medium Clays
  • Loading Diagrams for Stratified Soil Profiles
  • Sliding Wedge Analysis Method
  • Water Pressures
  • Earth Pressures Due To Surface Loads
  • Uniform Surcharge Loads
  • Point Loads, Line Loads, and Strip Loads
Ground Anchor Design
  • Location of Critical Potential Failure Surface
  • Calculation of Ground Anchor Loads from Apparent Earth Pressure Diagrams
  • Design of the Unbonded Length
  • Compression Anchors
  • Design of the Anchor Bond Length
  • Spacing Requirements for Ground Anchors
  • Selection of Prestressing Steel Element
Wall Design based on Lateral Pressures
  • Design of Soldier Beams and Sheet-Piles
  • Design of Lagging for Temporary Support
  • Design of Wales and Permanent Facing
Lateral Capacity of Embedded Portion of Wall
  • Evaluation of Ultimate Passive Resistance
  • Soldier Beam and Lagging Walls
  • Continuous Walls
  • Depth of Penetration below Excavation
  • Comparison of Wang-Reese and Broms Method for Competent Soils
Ground Mass Stability
  • Basal Stability
  • Evaluation of Bottom Heave Potential in Soft to Medium Clays
  • External Stability
  • Evaluation of External Stability Using Limit Equilibrium
Tiedown Design
  • Uplift Capacity of Rock Tiedown Anchors
  • Uplift Capacity of Soil Tiedown Anchors
  • Design of Tiedown Anchors to Resist Hydrostatic Uplift
Seismic Design
  • Internal Stability Using Pseudo-Static Theory
  • Lateral Earth Pressure
  • Wall Design Considerations
  • Liquefaction
  • External Stability
  • Pseudo-Static Analysis
  • Seismic Deformation Analysis
Corrosion Considerations in Design

Corrosion and Effects on Ground Anchors
  • Mechanism of Metallic Corrosion
  • Types of Corrosion for Prestressing Steel
Corrosion Protection of Ground Anchors
  • Requirements of Corrosion Protection Systems
  • Design of Corrosion Protection Systems
  • Anchorage Protection
  • Unbonded Tendon Length Protection
  • Tendon Bond Length Protection
  • Protection Against Stray Currents
  • Corrosion Protection of Anchors for Structures Subject to Hydrostatic Uplift
Selection of Corrosion Protection level
  • Service Life of the Anchored Structure
  • Aggressivity of the Ground Environment
  • Consequences of Failure of the Anchored System
  • Cost for a Higher Level of Protection
Corrosion of Structural Steel, Cement Grout and Concrete
  • Corrosion and Protection of Steel Soldier Beams and Sheet Piles
  • Degradation and Protection of Cement Grout and Concrete
Load Testing and Transfer of Load to the Anchored System


Concepts for Monitoring Anchor Bond Zone Capacity

Testing and Stressing Equipment
  • Equipment Used in Load Testing
  • Hydraulic Jack and Pump
  • Stressing Anchorage
  • Pressure Gauges and Load Cells
  • Dial Gauge to Measure Movement
  • Jack Chair
Anchor Load Testing
  • Performance Tests
  • Procedures for Performance Test
  • Recording of Performance Test Data
  • Analysis of Performance Test Data
  • Proof Tests
  • Proof Test Procedures and Recording and Analysis of Proof Test Data
  • Extended Creep Testing
  • General
  • Procedures for Extended Creep Test
  • Recording and Analysis of Extended Creep Test Data
  • Acceptance Criteria
  • Creep
  • Apparent Free Length
  • Ground Anchor Acceptance Decision Tree
  • Modification of Design or Installation Procedures

TLNT reserves the right to cancel or change the date or location of its events. TLNT's responsibility will, under no circumstances, exceed the amount of the fee collected. TLNT is not responsible for the purchase of non-refundable travel arrangements or accommodations or the cancellation/change fees associated with cancelling them. Please call to confirm that the course is running before confirming travel arrangements and accommodations. Please click here for complete policies.

Education @ Your Desk. A Live Webinar Class means that you will attend the class via the web using your computer. There are scheduled breaks for coffee and lunch. You use a microphone, headset, or your phone and are able to interact with the instructor and other students while following notes while watching the presentation slides online just as you would in a live classroom. Notes are posted online. For an extra cost a hard copy can be requested.

The virtual classroom is becoming more and more popular, and we have a lot of experience teaching in this format. The only real difference between a live in-class and live via webinar is where you sit and what you look at. You can learn from the comfort of your own home or office. You pay less for the live webinar format than you would for the in-class format, and you do not have to travel to another city to attend the class. Please contact us at for Special Group & Corporate Rates for one or more participants.

We could offer any of our courses at a location of your choice and customized contents according to your needs, please contact us at : or click here  to submit an online request.

PC-based attendees
OS: Windows XP, 2003 Server, Vista, 7, 8
Internet Explorer 7.0 or newer
Mozilla Firefox 4.0 or newer
Google Chrome 5.0 or newer

Macintosh based attendees
OS: Mac OS X 10.6 (Snow Leopard), 10.7 (Lion), 10.8 (Mountain Lion) or newer
Safari 3.0 or newer
Mozilla Firefox 4.0 or newer
Google Chrome 5.0 or newer

iPad 1 or newer, iPhone 3GS or newer, iPod Touch (3rd generation) or newer
OS: iOS 6 or newer

OS: Android 2.2 or higher

Course Materials

Each participant will receive a complete set of course notes and handouts that will serve as informative references.


Need a Government Grant?
Employment and Social Development Canada Grant

Jumpstart your training with the help of Talented Technology Training Canada (TTT-Canada) & the Canada Job Grant.

Seminars and Workshops offered within your organization anywhere in the world.

Offline Registration

To Register by fax, download and fill our registration form, then fax it to (888) 849-4871. Mail your cheque to our address.

If you have a question regarding this course, please click here to contact us.
Related Courses
CEUs Certificate

A certificate of completed Continuing Education Units (CEUs) will be granted at the end of this course. A fee is required for all complimentary webinars.

On-Site Training

This course can be customized and delivered on-site at your facility.

Stay on top of your profession development with useful articles and industry updates Subscribe